LIQUI MOLY DPF Wand w/ 5 Interchangeable Tips
CA$344.43
In stock
SKU
7945
Content | 500 ml |
---|---|
Application | Cleaning is performed with the DPF Pressure Cup Spray Gun (part no. 7946) and the specially developed DPF Gun with 5 spray probes (part no. 7945). Depending on the type of vehicle, access to the diesel particulate filter is to be established. On most vehicles, the temperature or pressure sensor of the diesel particulate filter must be removed for this. Note: The temperature of the particulate filter during cleaning should be less than 40 °C. In some vehicles the diesel particulate filter is located near the exhaust manifold or in some cases the turbocharger rather than on the underbody. For safety reasons, extreme care must be taken when cleaning these vehicles to ensure that no cleaning or flushing fluid gets into the combustion chamber through an exhaust valve that has been left open. The appropriate Pro-Line Spray Probe for the type of vehicle is introduced into the particulate filter through the opening that is created. The total amount of Pro-Line Diesel Particulate Filter Cleaner cleaning fluid (1 l) is sprayed directly onto the surface of the particulate filter in several intervals of 5 - 10 seconds with a break of 5 - 10 seconds in each case at an operating pressure of 6 - 8 bar. In order to coat the entire surface with Pro-Line Diesel Particulate Filter Cleaner to the greatest possible extent, the probe must be turned and moved back and forth when cleaning. Wait approx. 15 minutes to allow the cleaner to take effect. The particulate filter is then rinsed with the total amount of flushing fluid (500 ml) with Pro-Line Diesel Particulate Filter Purge. Processing is likewise performed with the DPF Pressure Cup Spray Gun (part no. 7946) at the same intervals as for the cleaning fluid. The cleaning process dissolves the soot enough and distributes it in the particulate filter so that it can be burned off with normal regeneration. After the sensor has been reinstalled, the service operation or the workshop must initiate a regeneration according to the manufacturer’s specifications. Attention: Refer to the safety data sheet for the protective measures to be taken when handling the product. |
Package Unit | 6 |
Pallet Unit | 840 |
Highly effective fluid for flushing passenger car diesel particulate filters (DPF/FAP) after cleaning with Pro-Line Diesel Particulate Filter Cleaner when installed. Secures optimum vehicle handling, engine performance and low fuel consumption. The layer of soot is softened by the cleaner, and the soot is dissolved and distributed in the diesel particulate filter so that it can be burned off with normal regeneration. Flushing occurs with a DPF pressurized tank spray gun (part no. 7946) and the specially developed DPF-Probe with 5 interchangeable tips (part no. 7945).
PRODUCT VARIANTS
Product Name | SKU | Bundle | Languages |
---|---|---|---|
Pro-Line Diesel Particulate Filter Purge | 5171 | 500 ml Can plastic | D-GB-I-E-P |
Pro-Line Diesel Particulate Filter Purge | 2820 | 500 ml Can plastic | GB-DK-FIN-N-S |
Pro-Line Diesel Particulate Filter Purge | 20914 | 500 ml Can plastic | JP |
Pro-Line Diesel Particulate Filter Purge | 20711 | 5 l Canister plastic | D-GB-I-E-P |
Fitments
Featured Product | No |
---|